Chinese RussianSpain

News

Home > News > Tips on How to Choose Solid Control Equipment

Tips on How to Choose Solid Control Equipment

Posted by:    Time:2014-04-02     click:

The performance of hydraulic interaction in the solid control equipment has a profound impact on oil drilling operators’ choosing solid control equipment because the oil drilling rate largely depends on this significant interaction. The mud weight also plays an important role in how to choose solid control equipment. In general, it is favorable to keep the mud weight down to ensure high performance of the solid control equipment. What is more, the oil drilling rate also, to some extent, depends on the fluid circulation rate and hydraulic interaction the other way round occurs when the drill strings are affected by the oil well pressures.

To be more specific, when choosing solid control equipment, oil drilling operators need to take the pulling pipes into consideration since high pressure formation fluids may enter the oil well due to the decreased pressure of the drilling mud. To prevent this from occurring, operators may run the pipes back into the hole so that the increased drilling mud pressure can help to break the formations even though formation fluids may continue to enter the oil well when the oil drilling is carried out under a high pressure zone. To conclude, if you have doubts on how to choose solid control equipment, you may refer to the following parameters: pump and solid pressures for kick operations, drilling rate, drilling torque and drilling position.

Control panels of de-1000 decanter centrifuge and the solid control equipment are mostly interfaced to the oil drilling process. To be more specific, the de-1000 decanter centrifuge control panel is used to open and close the sea floor and blow out preventer valves are used to close the oil well in a kick situation. What is more, the de-1000 decanter centrifuge choke manifold panel will direct the oil flow from the choke line to various chokes and the remote de-1000 decanter centrifuge choke control panel will adjust the choke opening when circulating out a kick.

At the same time, the alarms de-1000 decanter centrifuge panel can tell if the flow out of the oil well is greater than the flow being pumped into it which is a indication of potential kick. The de-1000 decanter centrifuge trip control panel is used to measure the volumes of the drilling mud going into or coming out of the well during the oil drilling operations, which contains breaks and draw works for tiny adjustments and is also used to set the rotary speed of the drill strings. Along with the solid control equipment, the pump and the mud control panel can be coordinated to adjust the oil pumping rate and the density of the drilling mud being pumped into the oil well.

Featured Products: desander | centrifugal pump

  • Label: