Currently, three heating methods have been adopted along with the where needs solid control system including conduction heating, convection heating and radiation heating in the oil drilling process. Compared with the first two Stack Sizer means, where needs solid control system need long retorting time and have low extraction rate but micro wave heating can greatly make up for the deficiencies of the system. By doing so, where needs solid control system can be dealt with in an easy manner thanks to the provision of aid to oil formation evaluation as well as maintenance of stability in the uncased sections in the Stack Sizer. Diesel oils used in the oil based drilling mud formulations can be found in where needs solid control system is needed even though it might be found to be toxic due to a wide range of microorganisms. The organisms are in high due to the concentration of potential materials so that highly refined base oil might have low concentration of aromatic compounds. The where needs solid control system rate may be the alternative in the used drilling mud as well as additives in the oil laden drill cuttings that still pose a threat to the aquatic and terrestrial ecosystems.
The discharge of oil based drilling mud in where needs solid control system as well as the release of crude petroleum along with many kinds of petroleum products into the natural environments have resulted in many problems. A lot of these problems have a global influence and requires where needs solid control system to be updated further more. The long persistence of such products in environments can be attributed to the low numbers of hydrocarbon Stack Sizer utilizes. The where needs Derrick shaker can be made full use of to reduce the toxicity level of crude oil on natural flora, according to the investigations of biodegradation of cutting piles that are associated with oil drilling mud. In the biological where needs solid control system, both bacteria and fungi have been developed and used so as to enhance the rehabilitation of environments that might be polluted with crude petroleum and its products. Micro wave of the where needs solid control system has thermal effect on a lot of materials, by which the migration of ion and the rotary of polarity molecules have the relatively static transient of oil molecules. In other words, where needs solid control system can change the oil product discharge into dynamic and produces thermal effect in the inner part of the Stack Sizer. This is because in where needs solid control system, oil shale is a poor conductor of heat so that the utilization of conduction heating and convection heating will lead to a higher rate of getting oil from it.