Chinese RussianSpain

News

Home > News > Some Basic Tips for Drilling Equipment Operator for You

Some Basic Tips for Drilling Equipment Operator for You

Posted by:    Time:2014-05-19     click:

There are many parts about the drilling equipment . Different parts have different ways to operate. So it is very important for you to pay attention to different ways about operating the drilling equipment. There are some tips for drilling equipment operator for you, they are as follows.

Firstly, when you use the derrick, you should have a whole check after the derrick rise and down, whose purpose is to make sure other parts’ shape. What is more, you cannot remove or change the derrick’s beam, screw and other parts go-as-you-please. Besides, it is necessary for you to make use of the derrick in the scope of its own.

Secondly, what you should take care of is the water brake. When water brake has no water, you cannot use the winch. The rotor blade has its direction, so you cannot make wrong when you install it. Besides, when its weight is over 300kN, you should choose to use the water brake. Then, when the water brakes work formally, the drainage of empty should be allowed to drainage a little water. It is important for you to clear the water brake, which can avoid it become corrosion.

Thirdly, if you use the drilling fluid purification equipment, you should learn about some useful tips. Before you use it, you should make sure the bed cleaning device is strong, the water hole has no jam, and the pressure gauge and the transmission belt cover are good. Besides, it goes without saying that you should check the sand pump’s oil and transmission part periodically to make sure it meets the requirement. If you use it in winter, you should ensure the demand has no drilling fluid.

Fourthly, what is worthy to say is that when the diesel engine does not work for a long time in winter, you should put off the cooling water in a suitable time. When the environment’s temperature is lower than the oil freezing point, you should take action to release the oil. If you have to stop the machine which is working in an emergency condition, you should open the cylinder head to give out the gas plug.

Finally, I want to share some tips about the electric drive system with you. It is known to us that we should ensure the screw fastening parts is formal. Besides, it is necessary to clean the dust on the bus, parts to support and socket head. What’s more, you have to choose to stop the electricity to have a whole check. Sincerely hope these tips are useful for you.

Different drilling equipment has different ways to operate. Before you operate your machine or machine’s parts, you should pay attention to the tips for drilling equipment operator what I have told you.

Featured Products: mission pump | shear pump

  • Label: