Chinese RussianSpain

News

Home > News > Solid Control System Experts Tips on maintenance

Solid Control System Experts Tips on maintenance

Posted by:    Time:2014-06-26     click:

Solid control equipment is now enjoying its popularity in many fields with a wide solid control system application. The maintenance of solid control equipment is vital for all the solid control system customers, reasonable maintenance can ensure a longer service life of solid control equipment. Here are some solid control system expert tips on maintenance, hoping it can offer some practical help for you.

(1) The Maintenance of Vibrating Screen

The first solid control system expert tip is about the maintenance of vibrating screen. Check each part of the vibrating screen per class duty and the screen surface must should be cleaned clearly when shift change. Circular shaker screen eccentric axis should filled lubricating oil once every 50 hours, while the linear sieve gear box should be filled oil once a month and the oil changes every six months. The equipment should be checked for an adjustment, lubrication and cleaning every 500 hours of operation, and you also need to replace some vulnerable parts. Users should make a complete maintenance every 4000 hours of operation, which includes checking screen frame, bearing and replacing the spring.

(2) The Maintenance of Degasser

In addition to solid control system expert tips on the maintenance of vibrating screen, there are some advices on degassers’ maintenance. The bearings of sand pump and vacuum pump shall be filled lubricating oil once every 12 hours when working, adding lubricant until the vent overflows each time. Draining the drilling fluid in all the pipeline, sand pump, vacuum pump and degasser before stopped used in winter.

(3) The Maintenance of Decanter and Cleaner

Be similar to the first solid control system expert tip on maintenance of vibrating screen, the decanter and cleaner should also make a complete maintenance every 500 hours of operation, which includes checking screen frame, bearing and replacing the spring. Make sure there is no residual drilling fluid in all the pipes, sand pump and flow spiral device before stopped used in winter, and clean the flow pipe and spiral device with clear water.

(4) The Maintenance of the Centrifuge

On one hand, check the magnetic plug on the bottom of gear box and remove the metal debris for every 100 hours running on end. On the other hand, checking coupler’s oil once every 100 hours of operation, if lower than the oil scale line, you should add turbine oil timely. What’s more, the level of belt tension must also be examined for every 100 hours running, thus keeping the device in a normal order, we do not allow the belt to run with no shield protection.


Featured products: king cobra screen | brandt shaker

  • Label: