Chinese RussianSpain

News

Home > News > Simple Training for Solid Control Equipment Users

Simple Training for Solid Control Equipment Users

Posted by:    Time:2014-03-06     click:

No matter water wells, oil wells or the pools, all those constructions are closely connected with various kinds of huge machine in the every producing steps. These wells or pools are easily accumulated sand in the edge or the center of the sites. One of the important job is to cast and screen them out during the process of installation. In the procedure, you could use the shear pump or sand filter to accomplish the work. When the well is well installed, you have to wait for at least 24 hours to do the next procedure.

Then you can spread the well and try to shaker screen the sand out and remove it. At the same time, so will the other mixed debris in the mixture. If the process is done in a great way, you can make these impurities totally out of the raw material and get the purer liquids. And you can screen out much finer debris in the liquids. The job could be well developed by the machine like sand filter or the shear pump. Well development can be effective and more efficient after a period of the time of the sedimentation to complete the task.

As the operator of these machine, there are always some simple train for sand pump users when they use them for the first time. Generally you have to remove the cap of the well of the pool or other equipment existing on them. It is obvious for the job. Put a surge block in or beside the plunger. You can skip the process since it is so trivial. We have to know that the details determine success or failure. So you have to check the every single process before you starting the work. Make sure the positions of the plungers near the well. You can make a sketch to mark the place of everything in the sites, which can really help you to better plan your constructing procedures.

Particularly, the well has a pan with the rubber bands to make a balance, which is actually attaching to the wall of the well or to a handle. You might moving it while you operate the machine. It will brush the edges of the casing and shake the liquid and make the water, oil or other liquids mix with the sands and other debris. It will be easier for the sand to be removed after the mixture coming into being. Then you have to stick a submersible or something similar to it into the big plain of the pool or the well. Then you can pump the water and the mixtures out. The liquid will run clear gradually, and you can let them flow over the land surface.

Featured Products: VSM shaker | derrick shaker

  • Label: