Chinese RussianSpain

News

Home > News > Preparations for Maintenance on the Sand Pump Machine

Preparations for Maintenance on the Sand Pump Machine

Posted by:    Time:2014-03-06     click:

You might encounter the all kinds of the problems of your mission pump in the constructions sites, or the sand pump on the in-ground pool. Actually they are all using a same pump system with the same working process. There are subtle difference between different kinds of the pumps that you have to figure them out. You have to be clear about where needs shear pump, sand filter or sand pump and mission pump. While they look alike with each other, they are used in all different areas.

Generally, all the aboveground wells or some of the swimming pools share a same pump filtration system. So they might have the same problems in the working process and with similar maintenance procedures as well. One of the effective machine is the mission pump. It usually use the debris or other impurities as a kind of filter media to make the working process much effective and efficient than it used to be. The process of producing clean liquid is also accelerated. Since the process becomes faster but more complicated, every little mistake or the repair work have to be solved in time. The problems and difficult situations have to be settled down through the right operation.

There are some difference between the different types of the machines. But you can get to know the common working procedures of the machines then you can know the problems in a better way. Furthermore, once you get to know that how it works then you could figure out that why the mission pump isn’t working. The pump often draws the water in through the well or the pool filters and all through the bed of the debris. Then the liquid is leaded back to the well through the nozzle for emission. Then the chamber of the mission pump, which is assembled with a backflow valve, can be used to repair the equipment. In addition, the debris or the sand in the filter is usually specially prepared with particular size and density. It is required by the assembly line part in the machine. And there is a gauge in the camber for you to know the pressure in the cabin.

You can make some test before you use a new mission pump or a repaired one. You can turn on the sand pump in the right place near the well or pool. In general the filter liquid is pumped or cleaned for around two times per day. Since the machines are different from each other, the time could range from about 2 hours to 3 hours each time. If the maintenance is well done, the testing process could be smooth and go very well. You can also read the timer on the machine itself which must be more accurate than your recorders. So the test job is much easier for users than before. 

Featured Products: VSM shaker | brant screen

  • Label: