Chinese RussianSpain

News

Home > News > Important Tips for Solid Control Equipment Operator

Important Tips for Solid Control Equipment Operator

Posted by:    Time:2014-06-05     click:

Purification treatment equipment is one of the three parts of solid control system . The shaker is one of the components of purification treatment equipment. Among the shakers, the VSM shaker can let the mixture more even and the supplies mix more sufficient. In this text, we will focus on the tips for solid control equipment operator.

Tips for solid control equipment operator of starting machine

1. First open the water valve, use water to immerse the roller for a while, and then open the auxiliary engine.

2. Start the auxiliary engine, check if there is any abnormal phenomenon on motor running. After being running for 30 seconds, only can the operator start the main motor.

Tips for solid control equipment operator of closing machine

1. Close the ball valve on the liquid inlet tube; open the flush valve on the liquid inlet tube and the tank. The washing time cannot be less than 10min.

2. Never stop the auxiliary engine when the drum rotates at a high speed or the auxiliary engine will be broke down. After the centrifuge has been shut down, open the upper cover of the tank and use water to clean its inside.

Tips for solid control equipment operator of vibrating screen

1. When the drilling fluid flows from the bottom hole has much soil or flow, augment the upward angle. When coming across the situation of draining sand, operator can adjust the straining box’s angle until the device works normally.

2. Before start the motor, check if the motor sheers off first, then start. Make sure the diversion between the motors is opposite or the vibrating screen cannot work.

Tips for solid control equipment operator after they finish using

Use water to clean the rotor, inspired gas, gas collecting chamber and foam separator after using. Eliminate abnormal matters and check if there is any damage on the parts.

Tips for solid control equipment operator of coupler

1. When the coupler continues working, the working oil temperature shall not exceed 90℃.

2. When the oil temperature exceed 125℃, the fusible plug will melt to protect the coupler because of the oil spray.

Tips for solid control equipment operator of drilling fluid flow

The drilling fluid flow cannot exceed the design processing capacity of centrifuge or it is easy to cause overload. This will cut the safety pin or drop the clutch.

Featured Products: 518 centrifuge | shear pump

  • Label: