The solid control system takes a significant role on industry production, thus we should find proper approaches to apply it. Today, I will answer this question of how to use solid control system as following:
About how to use solid control system , fist should consider installing it. Practical steps as following:
Installation of the system positioned reference in the middle of the wellhead center, locate as the following order:
① No. 1 tank positioned installation;
② Unicom inserted into the connector on the 1st part of the 2nd Tank mud tanks and mud pots on the 3rd;
③ Install the 2nd mud tank by drawing on the dimension depends on the system above;
④ Install all external manifold of 2nd mud tank, namely pump suction pipe, mortar into the tube, pipe between the tank closed tube.
⑤ Install all external manifold of 3rd mud tank, namely pump suction pipe, mortar into the tube, pipe between the tank closed tube.
⑥ Install location bar on the 4th of mud pots and mud tank between each.
Through above steps, how to use solid control system has completed a large part of the task, then install shaker, except sand cleaners, centrifuges, sand pump, shear pumps and mixers and other equipment were aligned with the corresponding position installation and use of appropriate thickness iron adjust it and finally compression bolts. Through these installation steps can successfully answer the first question how to use solid control system.
The second answer about how to use solid control system is its operation.
① All shear pump must ensure that the sand pump and the suction port is located within the tank above the liquid level position to open the suction port, and all sand pumps and cut pumps must be open in a suction port.
② When just beginning to use, need to train operator so that strictly operate procedures.
③ The solid control system is a collection equipment, including a variety of units, according to safety when operating the device work carried out the order.
④ When used to ensure that each unit can work, avoid affecting the overall efficiency of the device.
In order to resolve the second question of how to use solid control system, sometimes we need professional guidance and then operate.
The last part of how to use solid control system is that learn of this equipment maintenance, several knowledge concluded:
① Check whether the pump suction filter is clogged, regular cleaning of its foreign body, smooth.
②All manifold prior to each connection, check the seals, rubber gasket is intact, if there is damage must be replaced.
③Mud tanks need regular maintenance rust, paint rust and other operations once every 2 years and so on.
Done above steps, it almost learn that how to use solid control system. Of course, as solid control system is complicated, how to use solid control system also need to pay attention to coordinating works of the various devices.