Chinese RussianSpain

News

Home > News > Desilter and the Required Flow Rate

Desilter and the Required Flow Rate

Posted by:    Time:2014-05-08     click:

When it comes to the choice of desilter , in general most people would consider a number of factors before they buy desilter since a proper desilter may have important impacts on the overall working performance of the oil drilling process. As a matter of fact, to buy desilter, a method has been specially figured out so as to mitigate the negative effects of vortex motion insider the chambers of the 518 centrifuge in the desilter. By doing so, oil drilling operators are capable of getting better use of a variety of resources and at the same time, reducing the risk that is related to loss of prime.

Engineers and scientists in the field of 518 centrifuge have studied the influence of a rotating 518 centrifuge device on the vortex motion of the desilter, especially in the case of a vertical oil drilling pipe system. In general, the 518 centrifuge is consisting of three thin vertical cylinders that are typically mounted on a horizontal rotating disk that is placed in front of the 518 centrifuge inlet section of the suction pipe. What is more, according to the experimental research that has been conducted for various diameters of the 518 centrifuge cylinders, the levels of liquids in the devices, or more specifically in the chambers, need to be kept in a certain flow rate so as to ensure the proper performance of the machine. And it is assessed that the desilter vortex type as well as the living life of vortices can be expanded thanks to this innovation, in comparison to the devices that are used to assess the efficiency of the desilter solution.

Therefore, we may say that by using the desilter, a decrease of about twelve percent to fifteen percent of vortex arising can be observed and recorded in most cases, which is also true for the suction chamber in 518 centrifuge and for most of the centrifugal pumps that are required to have a certain level of flow rate. To be more specific, if 518 centrifuge is identified to have high flow rates as well as low water level, it means the suction chamber are at the same time present with violent vortex motion, which may have the potential to block the rotating device and reduce the volume of air entered the oil drilling systems. In other words, the influence of 518 centrifuge is massive and that of the flow pattern in the suction chamber is always attached to great importance, which can be visualized using in the control center with the help of the inlet section through which one can observe two main 518 centrifuge flow pattern in the piping system.

Featured Products: shear pump | stack sizer

  • Label: