Along with distance to oil drilling wells, when we choose to buy sand pump, we also need to consider the proximity to bottom streams in the discharge areas. Apart from knowing mud gun usages, we should also learn more about structural front and the index for the trend of sand pump. This is largely because mud gun usages should be well adapted to the increasing thermal maturity as the oil exploration project goes on. What is more, the degree of tectonic deformation has been suggested to influence the choice of sand pump, which is especially true in dissolved oil and gas concentrations. Of these factors, distance to the wells is the dominant statistical factor for sand pump and other solid control equipment. In contrast, the distance is also significant for methane concentrations analysis with the help of linear regression.
For single correlation factors concerning mud gun usages, distance is again the dominant statistical term. For observed oil concentrations, distance to oil wells is the only factor in the dataset that is statistically significant. This is true about mud gun usages regardless of whether the usages can be analyzed by multiple regression or Pearson correlation. The reason is very simple that isotopic signatures and oil drilling ratios provide additional insight into the sources under the ground. Sometimes mud gun usages even suggest the origin for methane with a derived methane source. Across the dataset, the most characteristic signatures of mud gun usages are in general found in wells with elevated rigs. In fact, all oil drilling wells with methane concentrations tend to have signatures consistent with mission pump and natural gas.
Therefore, the increase of mud gun usages is more rapid than those in the experimental set-ups. The wide usage of mud gun and sand pump could lead to additional activities concerning oil drilling. What is more, experts also detect a certain degree of decrease in oxygen if we use sand pump. This is probably due to the greater oxygen consumption that is required so as to break down the oil pollutants inside the mud gun and sand pump. And we all know that oxygen is essential if we want to upgrade crude oil and separate different levels of the oil products. Therefore, it is clear that with mud gun usages, the surrounding environment might change due to the drilling mud. This will be reflected in the initial heterotrophic hydrocarbons and it can be used as a substrate for growth. Therefore, sand pump can be used to enhance rehabilitation of oil drilling mud before it is discharged. By doing so, we can totally avoid pollution of human environment with oil and oil drilling materials.