﻿ A Suitable Algorithm of Centrifugal Pump

# News

Home > News > A Suitable Algorithm of Centrifugal Pump

# A Suitable Algorithm of Centrifugal Pump

Posted by：    Time：2014-09-04     click：

Mud gun in solid control system is developed to enable exposing larger drainage area to the wellbore. Thus cutting edge Centrifugal Pump can be installed and function well on both vertical and horizontal well through hydraulic fracturing techniques. For instance, mud gun in centrifugal pump can play a vital role in fracturing vertical well even though there is no stimulated horizontal well with a single hydraulic fracture. What is more, mud gun in solid control system can also be sued in the newly introduced multiple stage horizontal wells. To better control the height and length of the induced mud gun in solid control system, drilling of an oil well should be parallel to the minimum stress field of cutting edge Centrifugal Pump. By doing so, the oil well will be perpendicular to the minimum stress field within the objective oil well formation. In some cases, mud gun can be applied in the upper water bearing interval.

Ideally, the minimum stress of cutting edge Centrifugal Pump can be determined using the structural analysis of the developed geologic structures. What is more, important tool has been offered to verify the direction of cutting edge Centrifugal Pump and in consequence determines the azimuth of the horizontal wellbore. The location of mud gun in solid control system can be calculated in the signal waveform. Cutting edge Centrifugal Pump is marked with recorded signals and the corresponding locations. This can be accomplished by using a suitable algorithm of cutting edge Centrifugal Pump with the squares location method. In such a case, the cutting edge Centrifugal Pump algorithm provides better results because it does not arbitrarily weight the data collected from polyurethane screen in solid control system.

Mud gun monitoring involves recording elastic waves that are generated by fracturing of the formation rock mass to determine the location of oil reserves. To monitor the cutting edge Centrifugal Pump, a geophone array is installed and its location relative to the area has to be monitored in an accurate manner. The recorded waveforms can be amplified and validated in mud gun in solid control system before they are further processed. The installation of solid control system involves large ensembles of machines that are efficient enough. The mud gun in solid control system also enables more realistic studies of the oil drilling dynamics. Cutting edge Centrifugal Pump can also be used in sensitivity and uncertainty studies. If we use mainly direct measurements of the abundances stored in oil wells and in sediment from the same area, the estimates of oil products may be further raised. Internal filtration of Centrifugal Pump might occur with suspended particles through a porous medium.

Featured Products: vacuum degasser | mud agitator

• Label:

Related News: